What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 21.06.2025 06:22

The other is “what does a “fuse” do?”
2024–10–14 [Omar Gharbi Omar Gharbi ]
But it can get overloaded, and no longer works.
What are your thoughts on the dating app "scam"?
The third is lightning and “how it gets conducted into a home.”
2024–10–16 [ OO OLAOYE OYEBODE ]
It also is a device that limits the change in current flow.
How far does good behavior take you in a prison?
He then asserts :
the problem then depends on "how fast does the fuse operate?".
This is the picture of an electronic coil of wire wound around a core of magnetic material.
so, what happens?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
He then describes Rainy Season and Lightning.
eight
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Here is a simplified AC power diagram.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Which one is better to guys, boobs or butt?
The MOV will conduct when the voltage exceeds 50% of line voltage.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
a photo is worth a thousand words.
An AC voltage/ current source, and an ac inductive load.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Because the load is inductive, the current lags the voltage.(by a bit).
One
nine
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
But… the neutral is now “floating” because of the 1 ohm resistance.
It seems Mohan does not understand the difference between a comment and an Answer.
Upvotes:
What happened to your school bully?
[old diagram got deleted by accident]
He then describes the function of a fuse.
This device then solves the entire problem.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
[image of Common-mode choke]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What is the most inappropriate experience you have had with a friend's daughter?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This one hit behind the barn.
A fuse is a non-resetable over current circuit protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
At one ohm, the resistor has a maximum of 1 watt power.
what exactly is a ‘surge’ protector?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Now when you have a certain ac resistance, then a current flows in a loop.
but I think this circuit , shows a few more pieces.
Edit 2024–10.
In schematic diagrams this is the symbol for a fuse:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
A circuit breaker is similar, but is resettable.
For this case there are devices called Metal oxide varistors (MOV).
This is where this question deviates from being a 'generic' question, and becomes more specific.
What is lightning?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
First Sentence:
but this device (an Inductor) … impedes the rapid changes in the current.
This is 'the assistant's answer'
These are simplified answers to the original question, and does not change anything I wrote above.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
I post the exact comment here.
This is where the MOV conducts again, and dissipated the energy.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
At least they know the answer if they wanted it.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–10[John johnson John Johnson ]
The bolt then partially travels down the line to your home.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
(Dc diagram shown, AC is similar).
Barnstars:
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There are two important concepts here.
What does a fuse do?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
One is “what exactly is in a ‘surge protector’ ? ”
These devices are installed between the “hot” and “neutral” and protective ground.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There are three different concepts here that are getting confused.